September 2013 - Engines & Parts Wanted

All Classified Ads

Brass Kuno timer wanted; Dave Williams nnn-nnn-nnnn (Norco CA)

Camshaft wanted for Cushman 4 hp model C; Uwe Schmidt nnn-nnn-nnnn (Cobble Hill BC)

Carburetor wanted, Schebler 3/4 brass for small marine engine; Dave Williams nnn-nnn-nnnn (Norco CA)

Igniter wanted for 2 hp Galloway; John Johnston nnn-nnn-nnnn (Medford OR)

Looking for a Julien stationary engine. I would prefer it to be complete or near complete, and free of any C/W/B; Jim Weiss nnn-nnn-nnnn or xxxx@xxxx.xxx (Stony Plain AB)

Sta-Rite parts wanted. Mine has a 6-3/16" piston and the flywheels are 36" in diameter. What do you have for this motor? W. Lenox nnn-nnn-nnnn or xxxx@xxxx.xxx (Oxnard CA)

Steel flat belt pulley wanted for 1945 3 hp Fairbanks Morse Z. Mounts to flywheel spokes on 4" hole centers & is approx 5" diameter; Tom Winterrowd nnn-nnn-nnnn (Canby OR)

Stover 4 hp T, 1910, parts needed: piston, casting number "T70", 5" diameter; hopper cooled cylinder with 5" bore; fuel pump; Rafe Crusch nnn-nnn-nnnn or xxxx@xxxx.xxx (Oakley KS)

Wade drag saw engine model SM 1 or similar engine wanted in good working condition or restorable. This engine must have crank shaft suitable for the hand clutch that was used on these drag saws; Mike Morgan nnn-nnn-nnnn (Onyx CA)

WANTED DEAD OR ALIVE one cylinder hit and miss engines any size any condition, will pay top dollar for rare engines and real big engines; Gordon Green nnn-nnn-nnnn (Medina TX)

Wisconsin single cylinder AENL or AENLD wanted, complete, running or not; Tim McPartland nnn-nnn-nnnn (Sutter Creek CA)