Alpha DeLaval 2-1/2 hp hit & miss barn fresh, complete, turns over. Has compression. With cart, $650 obo; Dale Somers nnn-nnn-nnnn (Medford OR)
Briggs & Stratton air cooled small engines, $100 each; Joe Salazar nnn-nnn-nnnn (Albuquerque NM)
Cushman 4 hp binder engine, with hand clutch, photos available, $400; Leonard nnn-nnn-nnnn (Santa Rosa CA)
Cushman carburetors: Two Schebler carbs for 4hp Cushman, one needs TLC, the other looks very nice, photos available, $125 for both; Leonard nnn-nnn-nnnn (Santa Rosa CA)
Economy 2-1/2 hp E, good project, turns free, missing parts, $175; Dave Itel nnn-nnn-nnnn (Aurora OR)
Ellis 3-6 hp engine parts. Have a cylinder/rod/gov.parts/side cover, more, some good, some poor. Can email photos, asking $130 USD or trades; Nathan Kehler nnn-nnn-nnnn or xxxx@xxxx.xxx (Newgate BC)
Engine collection: Due to old age and health problems I am selling my 25 year collection of engines. I am selling them as a package, priced accordingly. There are 20 engines in my collection at this time ranging from 1-1/2 hp to 6 hp. Seventeen of these engines are running or have run. One is a barn fresh Economy, One is a 3? hp Gray marine, and the 3rd one is a 1-1/2 hp Fairbanks Morse 1A that was fully restored as a show piece so I never ran it; Bob Johnson nnn-nnn-nnnn or nnn-nnn-nnnn or xxxx@xxxx.xxx (Cedarville CA)
Engines: I have ten motors remaining out of a collection of forty three and all but one is complete. They have been sitting inside a barn for 25 years and should run with a little TLC: International 6 hp M, $550. Fairbanks 6 hp, $500. Fairbanks 1-1/2 hp open crank with spoke flywheels, $400. Fairbanks Z style D, $200. Cushman Cub, $300. International LB, $250. Maytag single piston, $150. Sattley 3 hp air cooled, $125. Fairbanks that is in parts but appears to all be there, and a generator unit. If you take them all you can have them for $2500; Bob nnn-nnn-nnnn or xxxx@xxxx.xxx (Fresno CA)
Engines: Kewanee pump engine, vertical pump engine, partially restored, some new castings need machined, $3200; Fairbanks Eclipse, big gear pump jack engine, complete, unrestored, $950; Fairbanks Eclipse, 2 flywheel model, old restoration, $850; New Way Jewel, horizonal air cooled, unrestored, new tin. Runs. $ 1500; Sattley, odd ball, throttler, carb w/ fuel pump on head, Webster, $1150; Novo, 3 hp, restored, nice. $1100; Sparta, 2 hp, partially restored in primer, needs paint, $1000; Sparta, 4 hp "A" model very early ser # 755 with cart, runs, $2400; Ingeco, 1-1/2 hp barn fresh, mag-igniter $950; Fuller Johnson, pump jack engine, early smooth flywheel, restored, $550; International Titan, 6 hp tank cooled, t/g, it’s been sand blasted & primed, new cylinder sleeve, $3250; International Famous, 2-1/2 hp unrestored, missing fuel pump. $2250; Briggs FH, slat fin, barn fresh, stuck. $400; Always Ready 3 hp, rare upright, missing a few parts, needs lots of repair, $1500; Wards drag saw, nice restoration, steel frame, Wico, new Simmons blade, $600; I can send photos, and ship Fastenal if needed, also can deliver to Brooks Oregon swap meet, call for more information; Dale Fye nnn-nnn-nnnn or xxxx@xxxx.xxx (Shelton WA)
Fairbanks 2 hp H on iron-wheeled wagon. Embossed 'Fairbanks-Morse' lettering on the hopper. Complete, running engine, restored. Great little runner, $1500; Ron nnn-nnn-nnnn or xxxx@xxxx.xxx (Auburn CA)
Fairbanks 6 hp Z with mag and crank. Mag is hot, engine is stuck but shouldn’t take much to free up. Comes with Fairbanks buzz saw parts, $275; Dave Itel nnn-nnn-nnnn (Aurora OR)
Fairbanks Morse 1-1/2 hp headless, on iron wheeled wagon. Good runner, $550; Ron nnn-nnn-nnnn or xxxx@xxxx.xxx (Auburn CA)
Fairbanks Morse 1-1/2 hp Z gas engine. Open crank. Bosch type A mag. A couple of well-made reproduction parts. Dual fuel mixer. Has Compression. I have not tried to start it. It has been in storage for a few years. No cart. Can be picked up in Tacoma, WA or I can crate and bring to Fastenal for a fee. Shipping to be paid by buyer, $450. This is part of an estate sale; Jim Beeler nnn-nnn-nnnn or xxxx@xxxx.xxx (Tacoma WA)
Fairbanks Morse 1-1/2 to 2 hp Z Style D, photos available, $250; Leonard nnn-nnn-nnnn (Santa Rosa CA)
Fairbanks Morse 2 hp Z, solid flywheels, metal base, photos available, $300; Leonard nnn-nnn-nnnn (Santa Rosa CA)
Fairbanks Morse 20 hp Z tank cooled engine on iron wheel cart. Completely restored and painted. Running. Has been shown at several shows. Few of the 20 hp are still around, $8000; Wilbur Reil 530 756 1018 (Davis CA)
Fairmont Engine used in the railroads in years gone by, turns over, looks to be in good shape, steel spoked flywheels and has radiator, $400, also have a little hand carry 6 volt generator powered by gas engine from Montgomery wards, turns over and looks to be in very good shape, $100; Joe Giordano nnn-nnn-nnnn or xxxx@xxxx.xxx (Port Orchard WA)
Field Brundage 7 hp, 1915 hit and miss stationary engine on vintage steel cart. Running, in good to very good condition. Beautiful engine, not perfect, but quite nice! Asking $2750; Kim Keeney nnn-nnn-nnnn or xxxx@xxxx.xxx (Cottage Grove OR)
Fuller Johnson 4 hp, excellent runner on a cart, $1200; Ron nnn-nnn-nnnn (lv msg) or nnn-nnn-nnnn or xxxx@xxxx.xxx (Kingsburg CA)
Galloway 2-1/4 hp engine, with rebuilt Webster Tri-polar, plus hand crank, on skids, photos available, $650; Leonard nnn-nnn-nnnn (Santa Rosa CA)
Gas Engine Construction book (1902). Build your own 1/2 hp gas engine. 300 pages, $20 pp; Gustafson nnn-nnn-nnnn (Auburn CA)
Ideal R: Tag on the back reads Veron Edler Co. Los Angles, CA. Air cooled, EK mag, No carb. One flywheel needs a key that holds the flywheel onto the crank shaft. No shroud or fan. Heavy engine. Can be picked up in Tacoma, WA or I can crate for a fee and bring to Fastenal for shipping. Buyer pays for shipping. $350. This is part of an estate sale; Jim Beeler nnn-nnn-nnnn or xxxx@xxxx.xxx (Tacoma WA)
International 1-1/2 – 2-1/2 hp LB complete. Last run several years ago, $325; Ray Bathrick nnn-nnn-nnnn (North Bend OR)
International 4 cylinder headless type with mag, brass radiator, hand crank. Has new valves, rings, runs smooth, $1000; Joe Salazar nnn-nnn-nnnn (Albuquerque NM)
International Famous 3 hp with Webster JZ mag on a homemade cart. Complete engine. About 80% original paint. Old repair on the water jacket nicely done. Wooden skids look original, but part of them have been painted so I cannot be sure. They might have had some boards replaced. Good compression. Original water tank too. Reproduction IH Famous muffler, $2500; John Billing nnn-nnn-nnnn (Edgewood WA)
International Harvester Mogul 4 hp hopper-cooled sideshaft. On original skids and fuel tank. Restored, painted Mogul green with polished brass fuel lines and magneto. YouTube video of it running for those of you who play on computers. https://www.youtube.com/watch?v=V4I-7dmX2Ls Includes standard pulley. High quality engine. Not cheap; John Billing nnn-nnn-nnnn (Edgewood WA)
John Deere 1-1/2 hp E, war model, not complete, rusty, $100; Dave Itel nnn-nnn-nnnn (Aurora OR)
John Deere 3 hp E, complete, stored 10+ years, never run, $800; Ray Bathrick nnn-nnn-nnnn (North Bend OR)
Maytag twin cylinder, needs cleaning and paint job, should start right up, photos available, $150; Leonard nnn-nnn-nnnn (Santa Rosa CA)
Misc. engines: Iron Horse engine, $100. Wells engine, $150. Delco-Light Plant, $500; Joe Salazar nnn-nnn-nnnn (Albuquerque NM)
Nelson Bros. Little Jumbo 1-3/4 hp, missing mag, welded rocker arm. Can of other parts, $275; Ray Bathrick nnn-nnn-nnnn (North Bend OR)
Peerless 2 hp vertical (Bates and Edmunds) on iron-wheeled wagon. Runner, $4500; Ron nnn-nnn-nnnn or xxxx@xxxx.xxx (Auburn CA)
Ruston and Hornsby 5 hp diesel 4-stroke sideshaft, $2500; Joe Salazar nnn-nnn-nnnn (Albuquerque NM)
Sparta "B" Economy 4 hp. 1909-1910. Nice slow running engine with the Holmes governor. Essex carb. Painted and pin striped. Very few of the early ones are still around. Complete with oiler and low tension coil. Standard pulley. No cart, $1500; John Billing nnn-nnn-nnnn (Edgewood WA)
Sparta/Economy 2 hp hit and miss gas engine. On a good cart with needle bearing wheels. Comes with a coil. Light on compression. These are nice running engines, I have not started this one. It has been in storage for a number of years. Can be picked up in Tacoma, WA or for a fee I will crate and bring to Fastenal. Buyer pays for shipping. $850. This is part of an estate sale; Jim Beeler nnn-nnn-nnnn or xxxx@xxxx.xxx (Tacoma WA)
Stover 1-1/2 hp K, 1921, sn K141403. Runs very slow, spoked flywheels, open crankcase, grease cup, rod bearing, oil hole main bearings, new gas tank, rebuilt Webster Tri-polar magneto, on 4 wheel cart. Runs good, $900; Danny Ponce nnn-nnn-nnnn (Los Angeles CA)
Stover 2 hp w/Wico, runs, on cart, $400; Ron nnn-nnn-nnnn (lv msg) or nnn-nnn-nnnn or xxxx@xxxx.xxx (Kingsburg CA)
Stover 22 hp, 1916 hit & miss on dual axle trailer, runs great! This 22 hp Stover has always been an easy starter (see video) and is a big hit at shows. It comes with a large wood display sign. It fires approx. once in 14 revolutions when cold and once in 25 revolutions when warmed up. It usually gets to 115 degrees at the end of the day (block filled with antifreeze). Also included is a custom Sunbrella cover (see last picture). Calif. registered trailer with tags & title. View video here: https://www.youtube.com/watch?v=dnURYFkV3R4 ; R. Kelly nnn-nnn-nnnn or xxxx@xxxx.xxx (Lompoc CA)
Stover/ Mitchell 1-1/2 hp K. Antique hit & miss with butter churn gear and pulley. Intake spring is weak. No cracks or breaks or welds that I can see. No cart. Has been stored for a number of years, should not take much to get it running. Will crate and take to Fastenal for a fee. Buyer will need to pay for shipping or can be picked up locally. $750. This is part of an estate sale; Jim Beeler nnn-nnn-nnnn or xxxx@xxxx.xxx (Tacoma WA)
Unknown 3-cylinder gas engine. It was made from cutting a 6 cylinder engine in half. I have seen this run a few years ago, but it has been in storage for a number of years and I have not tried to start it. It is electric start. I think it takes a 6 volt auto battery. No cart. Engine head has part number 255151-1. The block number is CWC525020. The tube stand is the engine’s cooling tank. Can be picked up in Tacoma, WA or I can crate and bring to Fastenal for a fee. Shipping to be paid by buyer. I can send pictures to your email, $450. This is part of an estate sale; Jim Beeler nnn-nnn-nnnn or xxxx@xxxx.xxx (Tacoma WA)
Unknown make 1-1/2 hp unknown name, hot head runs, battery and coil, on cart, $300; Ron nnn-nnn-nnnn (lv msg) or nnn-nnn-nnnn or xxxx@xxxx.xxx (Kingsburg CA)
Wisconsin AKN. Looks as new, mag rebuilt, etc, $125; Gustafson (new phone #) nnn-nnn-nnnn (Auburn CA)
Witte 2 hp. Boshe mag, runs, on cart, $400; Ron nnn-nnn-nnnn (lv msg) or nnn-nnn-nnnn or xxxx@xxxx.xxx (Kingsburg CA)
Wonder 2 hp by Construction Machinery Co,, hot head, runs, battery & coil, on cart, $300; Ron nnn-nnn-nnnn (lv msg) or nnn-nnn-nnnn or xxxx@xxxx.xxx (Kingsburg CA)