Aermotor open gear windmill wanted, complete or parts, any condition. Also want brake shoe for 10 ft Aermotor open gear, part #B190; Tony Giefer nnn-nnn-nnnn (Lindsay CA)
Ammunition wanted (antique); Hank Weigel nnn-nnn-nnnn (Carlton OR)
Combine wanted: John Deere pull-type, complete preferred: Mark Parker nnn-nnn-nnnn (Lebanon OR)
Gichner M1022 expandable shelter dolly parts needed: 8 locking bolts to fit container ends and one two stage lift cylinder; Jack Fusari nnn-nnn-nnnn or xxxx@xxxx.xxx (Madera CA)
Guns wanted: pre-1898 rifles and pistols; Hank nnn-nnn-nnnn (Carlton OR)
Guns: old rifles Remington, Winchester, Sharps or ?? wanted; Mark Parker nnn-nnn-nnnn (Lebanon OR)
Hay conditioner wanted, John Deere Model 22 or 32 or similar equipment. I am located in Western Washington and I'm willing to travel up to 500 miles or so to get it. Good working condition a must; Chris nnn-nnn-nnnn (Stanwood WA)
Info needed: I have two large cast iron wheels that I would like to know what they fit, both are 39-3/4 in diameter. One has 5 spokes, the other has 6, there is a casting number of A455N and the Case tractor emblem on one wheel. They are 4-1/4 in wide and appear to be crowned for a belt. One is for a keyed shaft about 1-7/8 and the other looks to be for a tapered shaft. Any help would be greatly appreciated; Jerry Bird nnn-nnn-nnnn (John Day OR)
Loader wanted: John Deere #67 loader to mount on a 750 John Deere; Randy Wixsten nnn-nnn-nnnn (Butte MT)
Minneapolis Moline farm equipment: wheel disk, plow, cultivator, or ??? wanted; Mark Parker nnn-nnn-nnnn (Lebanon OR)
Parts needed for a 1967 Worthington big blue 160 mono rotor air compressor I need the hydraulic jacking system that operates the clutch system; Jack Fusari nnn-nnn-nnnn (Madera CA)
Plow: any John Deere plow 2-6 btms 16"cut models: 44, 55, 66 and newer wanted; Mark Parker nnn-nnn-nnnn (Lebanon OR)
Polaris Sno-Traveler wanted, specifically a Voyager model. I may also look at a K-95; Ryan Gurney nnn-nnn-nnnn (Filer ID)
Torbensen rear axle. Axle ratio approximately 3.75 to 1. Total overall width 52-3/4 inches. Make offer; Gerald Hilden nnn-nnn-nnnn or xxxx@xxxx.xxx (Olympia WA)
Trailer wanted: 2 axle 20 foot goose neck trailer; Larry Busack nnn-nnn-nnnn (Longview WA)
Want John Deere ground driven corn binder; Dave nnn-nnn-nnnn (Boring OR)
Want old horse drawn equipment, complete or in parts, also especially looking for a complete horse drawn grader; Gary Martin nnn-nnn-nnnn (Bieber CA)
Wanted Older Ford CL30 or CL40 skid steer loader parts wanted, will consider whole machine running or not, built in the 70s to early 80s, had V4 Ford Industrial engines in them, need parts from these engines also; Joe Giordano nnn-nnn-nnnn or xxxx@xxxx.xxx (Port Orchard WA)