May 2016 - Vehicles

All Classified Ads

1921 White 3/4 ton, runs well, needs restoration or be fun in its original condition, $7000; Dave Mull nnn-nnn-nnnn (Independence CA)

1940 International, D5 35, cab and chassis 2 speed axel, cast wheels. Very little rust, runs, have title, $500; Boyd nnn-nnn-nnnn (Colfax WA)

1946 GMC with early cab, about a 2-ton with 12' bed. Very good sheet metal. This is a project but comes with many extra parts, $600; John LaBoyteaux nnn-nnn-nnnn (Upper Lake CA)

1950 Studebaker bullet nose 2-door coupe. Rebuilt engine, not only is there no cancer, the paint is original and no rust at all-near perfect original condition. New upholstery. Very nice original piece of history, $8750; Don Chappell nnn-nnn-nnnn (St Helens OR)

1951 Chevy half-ton pickup, $700; Scott Farmer nnn-nnn-nnnn (Dayville OR)

1952 Studebaker dump truck. Runs good, new tires, dump works good. Also parts truck to go with it, $800 obo; Jimmy Clayton nnn-nnn-nnnn (Lincoln CA)

1953 Cummins, NHB-200 single disk fuel pump and injectors, condition unknown. Being sold for cores. Also have Cummins low starter mount bell housing and oil pan, similar to what is used on the iron lung or super charge engines. If interested please make offer for all or part; Tim Morris nnn-nnn-nnnn (Napa CA)

1953 GMC 750 series truck, 4-71 Detroit, 5 speed transmission, aux. trans/brownie box, 2 speed rear axle. Complete, good sheet metal except there is some rust on back of the cab (only on flat metal). Has not run in several years, $1600; Larry nnn-nnn-nnnn (Phelan CA)

1954 Peterbilt conventional 3 axle, $3000; Sandra Kerr nnn-nnn-nnnn (Brentwood CA)

1963 Ford Falcon Ranchero. 6 cylinder 170 engine. Ready for restoration. Original color was red but has been repainted blue. Can send pictures, $2500 obo; Ronn Boehlke nnn-nnn-nnnn, nnn-nnn-nnnn or (Klamath Falls OR)

1964 Thiokol snowcat, model 1201, Ford 6 cylinder, full raised roof cabin, seats 6, front and rear heaters, very nice condition, delivery available, $9500; Boyd nnn-nnn-nnnn (Colfax WA)

1966 Ford F703, rebuilt 330 cid, 5+2 trans, equipped for 5th wheel or bumper pulling, full air brakes and electric brake towing, $15000; Robert McLaughlin nnn-nnn-nnnn (Benton City WA)

1973 International 1610, with 20' box, 345 V8, 5+2 trans, good runner, excellent condition, $4500; Robert McLaughlin nnn-nnn-nnnn (Benton City WA)

1976 Chevy. 454, 4 speed, 2 wheel drive, duals, flatbed with racks, 55k original miles, $1500; nnn-nnn-nnnn (lv msg) (Prineville OR)

1979, Caterpillar 3208 truck engine, with 5 speed transmission, good running, non-turboed, $2100 for engine, $400 for transmission or $2300 for both; Don Chappell nnn-nnn-nnnn (St. Helens OR)

1980's Ford 32 ft boom truck (man lift) telephone workers' truck, $2900 or trade. I am a Ham Radio operator and that’s the reason I bought the truck. I put it through the paces and it seemed to have bad gas in it. I had it running then and the boom (32 ft) operated but not correctly. It has bucket controls and also a ground control panel in the side box. It operates from the ground controls. It runs from a generator installed on the truck and runs from the truck fuel tank. As all projects go, some get pushed back as this one did for me. I had an incentive to let it sit as all my ham friends wanted me to get it finished up so they could borrow it or have me do projects for them, ha! This past October I moved it over to the garage and made it run, new gas etc. I replaced a leaky power valve in the carburetor, replaced the fuel pump and filter, and got frustrated with the starter kicking out so replaced it also. Now starts and runs very well. It is a 351 Windsor V8. Needs a bit of TLC and tinkering. I also hav

e an Electrical schematic. Truck title is free and clear, tires are good, needs battery. Update …again it has been sitting since October as I went South for the winter and just returned. My next step would be get the generator running then tackle the boom part. Email and I can send many pictures. We screen our calls so leave a message mentioning the truck and I will pick up but not without a message; Roger nnn-nnn-nnnn or (Manson WA)

1982 Chevy Luv 4 Cylinder Diesel 4x4 with power steering: I would like to trade it for a compact diesel tractor with loader. The truck runs great, just put a new timing belt/bearing on, new heater hoses, new water pump and new belts. Truck has some dents but I bought it from original owner and has 82xxx original miles; Greg Sullivan nnn-nnn-nnnn (Chiloquin OR)

1985 Ford F250 extra cab flatbed pickup. This is a one of a kind. It has been re-powered with a Turbo 7.3 diesel and 5 speed manual transmission. Approximately 60,000 miles since engine and transmission were rebuilt and installed. It has newer batteries, bucket seats with lumbar support and two under the bed side boxes. Can send pictures, $4750 obo; Ronn Boehlke nnn-nnn-nnnn, nnn-nnn-nnnn or (Klamath Falls OR)

1986 Mercedes Benz 420SEL runs well, can send pictures, $2300 obo; Ronn Boehlke nnn-nnn-nnnn, nnn-nnn-nnnn or (Klamath Falls OR)

1995, Ford F450, 7.3 L non-turboed engine, threw rod but lots of good parts. Complete at this time, want to sell complete, $575. 5 speed manual transmission, needs rebuilt, $250; Don Chappell nnn-nnn-nnnn (St. Helens OR)

Corvair rampside pickup, running, no title, $4500 obo; Robert McLaughlin nnn-nnn-nnnn (Benton City WA)

Many trucks for sale – 1921 White truck. 1946 Chevrolet 1-1/2 ton. 1938 GMC 2 axel semi tractor and more. All trucks have engines that will turn over, the White truck has two engines one with the starter ring. This is an accumulation of many years of pickin, and all trucks are projects; Don Stone nnn-nnn-nnnn (Prosser WA)

Mirrors: For 2010-2013 Chev Silverado: Electric mirrors with extended mirrors for 2010 to 2013 Chevrolet Silverado pickup, also black fitted dash cover, all for $200 obo. Call and we can email pictures; Mark nnn-nnn-nnnn or NO TEXT PLEASE !! (Ellensburg WA)

Quarter panels- New Super Scout Specialties fiberglass quarter panels for IH Scout II, includes fillers, $350; Ronn Boehlke nnn-nnn-nnnn or (Klamath Falls OR)

Wanted: Dodge power wagon truck, 1946-1968, any condition; Jerry VanDeWalle nnn-nnn-nnnn (Yamhill OR)

Wanted: Engine that will work for a Studebaker 62 2-door coupe; Jesse nnn-nnn-nnnn (Tillamook OR)

Wanted: Ford GAA-GAF-GAN tank engines and related parts wanted. They were manufactured from 1940 to 1950; Joseph Di Stanza nnn-nnn-nnnn (Phoenix AZ)

Wanted: Willis Overland station wagon, 6 cyl, 4-wheel drive in restorable condition; Jesse nnn-nnn-nnnn (Tillamook OR)