March 2018 - Tractors & Parts Wanted

All Classified Ads

Belt pulley attachments for Deutz tractors wanted; Buck nnn-nnn-nnnn (Greenville IL)

Complete Le Roi 2-cylinder engine for 1934 Centaur tractor wanted; Ray nnn-nnn-nnnn or xxxx@xxxx.xxx (Terra Bella CA)

Drawbar for John Deere GM, 1945, part number F650R wanted. This is the 6-hole long one, needs to be straight, we will be strengthening it for tractor pulling. Prefer locating along the I-90 corridor between Spokane and Seattle or around HY 395 to the Tri-Cities and on to Yakima; Gary Wooldridge nnn-nnn-nnnn (Spokane WA)

Farmall A, B, C parts wanted, need rear rims (2) 7x24 or 9x24, starter, always looking for tear drop light parts; ACE Tractor Parts nnn-nnn-nnnn (phone is broken, leave message and I will get back to you) (Redding CA)

Farmall A, B, C parts wanted: two clutch plates, two pressure plates, two throw-out bearings; Roger nnn-nnn-nnnn (Redding CA)

Farmall M wide front end wanted; Richard Parker nnn-nnn-nnnn (Lind WA)

John Deere 440 or 1010 crawler four roller track frames or complete parts tractor wanted; Bob Gauntt nnn-nnn-nnnn (Vancouver WA)

John Deere D 12v generator Delco number 1100956, wanted, complete; Mark Parker nnn-nnn-nnnn (Lebanon OR)

John Deere D, 1941, needs the air intake stack. I have the air cleaner; Hubert Bierly nnn-nnn-nnnn (Bend OR)

John Deere GM 1945 drawbar [ pn F650R ] wanted. This is the 6-hole long one, needs to be straight, we will be strengthening it for tractor pulling. Also I am looking for rear wheel weights. Prefer locating along the I-90 corridor between Spokane and Seattle or around HY 395 to the Tri City's and on to Yakima; Gary Wooldridge nnn-nnn-nnnn (Spokane WA)

Looking for a 3-3/8 piston for Le Roi 2 cylinder to fit a Centaur G tractor. Piston height is 3.2 and needs a .9inch diameter piston pin. Piston weight: 698 g (without wrist pin and rings). Compression height: 1.5" (center of wrist pin to top of piston). Wrist pin weight: 134 g. Number of rings: 3. The piston bore is 3-3/8 or 3.375. Single cast iron or 2 aluminum alloy. Also, complete engines tractors or parts for same; Ray Chrispens nnn-nnn-nnnn (Terra Bella CA)

Rumley H or K wanted in original condition, or any other pre-1930 steel wheeled tractor in original condition; Dale Martin nnn-nnn-nnnn (Ephrata PA)

Tires wanted: pair of 36” rear tractor tires wanted in good condition; Mike nnn-nnn-nnnn (Dufur OR)

Two cast iron front wheels wanted for a John Deere GPO; Dave nnn-nnn-nnnn (Boring OR)