Alfa DeLaval 3 hp, 1922?, throttle governed, EK magneto, older restoration, runs good, on skids, $450; Daryl Klein nnn-nnn-nnnn (Deming WA)
Atlas 4 hp tank-cooled engine, built before 1912, Indianapolis, (not a Kruger Atlas from Texas), $21000; Les Layton nnn-nnn-nnnn or xxxx@xxxx.xxx (Keizer OR)
CA Engine. Commercial 60 hp tank-cooled engine made in Los Angeles, CA. in 1915. Only known 60 hp type C engine. Runs great. Easy to start with air. I have started it in the past throwing it back against compression. This 8-ton engine is mounted on a 3-axle dedicated gooseneck trailer (CA license). Electric start gas air compressor for starting. A 6-inch United pump made in Oakland, CA is belted to the engine and can pump water for shows. The engine has not been painted. Has been shown at several shows. Complete unit is $14000. Will sell the engine separate for $11000. See video on Facebook https://www.facebook.com/wilburreil ; Wilbur Reil nnn-nnn-nnnn (Davis CA)
Case stationary power unit complete with clutch assembly and radiator, been inside, best offer; Matt nnn-nnn-nnnn (Denair CA)
Caterpillar D-353, spacer plate engine, currently set up as a power unit, complete radiator through power take off. Will also fit D-9G and D-9H tractors and marine applications. Excellent running engine, $11000; Mike nnn-nnn-nnnn or xxxx@xxxx.xxx for photos or video (Prineville OR)
Cushman binder engine. Nice original paint. Excellent compression. Have not ran this engine but should run with minimum effort, $400. Email for pictures; Tanner Remillard nnn-nnn-nnnn or xxxx@xxxx.xxx (Pendleton OR)
Economy 1-1/2 hp JK, not running, good Wico mag, some extra parts, $300; Richard Hanna nnn-nnn-nnnn (Hayden ID)
Economy JK, good EK Wico mag, 1-1/2 hp, not running, $325; Rich Hanna nnn-nnn-nnnn (Hayden ID)
Fairbanks 1-1/2 hp, hopper condenser cooler. Needs work, stuck, $225 or offer; Larry Jacobson nnn-nnn-nnnn or nnn-nnn-nnnn (Salt Lake City UT)
Fairbanks Morse 1-1/2 hp headless with igniter, on cart, Sumter mag (needs charged) runs with coil and battery, $850; Rich Hanna nnn-nnn-nnnn (Hayden ID)
Fairbanks Morse 15 hp Z, brass tag, 44" flywheels, lots of original paint, not stuck, complete with pulley and crank guard. Needs very little TLC; Jim nnn-nnn-nnnn after 6 (corrected phone number) (Lumby BC)
Fairbanks Morse 20 hp Z tank cooled engine built in 1920, on iron wheel cart. Completely restored and painted. Running. Has been shown at several shows. Few of the 20 hp are still around, $7000. See video on Facebook https://www.facebook.com/wilburreil ; Wilbur Reil nnn-nnn-nnnn (Davis CA)
Fairbanks Morse 3 hp Z, runs good, on skids, still in its work clothes, $400; Daryl Klein nnn-nnn-nnnn (Deming WA)
Fairbanks Morse 3 hp Z, sn 23437, made in Canada. Not running. In storage since 1995, $350; Richard Hanna nnn-nnn-nnnn (Hayden ID)
Fairbanks Morse 5 hp Z B, complete running engine. No CBWs that I know of, lots of original paint. Pictures on request, $600; Mark nnn-nnn-nnnn (call or text) or xxxx@xxxx.xxx (Hermiston OR)
Flywheels: 1) Early Stover, set of 2, $50. 2) Stover with round holes, set of 2, $50. 3) Fairbanks Morse, marked set of 2, one with built in crank handle, $50. Email for pictures and details; Kathy Repp nnn-nnn-nnnn or xxxx@xxxx.xxx (Snohomish WA)
Ford flat head engine. Engine is complete with mag and carburetor. No starter or generator. Comes with oil bath air cleaner, $500; Jon Rodgers nnn-nnn-nnnn (Sonora CA)
Fuller and Johnson 1-1/2 hp N, sn 17171, with tube gas tank, igniter, runs good, on cart, $750; Rich Hanna nnn-nnn-nnnn (Hayden ID)
Fuller and Johnson 3 hp N on steel-wheeled cart, runs good, $850; Rich Hanna nnn-nnn-nnnn (Hayden ID)
Gas engines: Briggs & Stratton Y. Iron Horse. Wells. Reo. Delco light plant. International 4 cylinder. Stover 2 hp K. Cushman 1-1/2 hp X. Make offer on each or all; Jose Salazar nnn-nnn-nnnn (Albuquerque NM)
International LA 1-1/2 - 2-1/2 hp, all original running engine w/ flat and V belt pulley. No CBWs that I know of, $400. Pictures on request. Mark nnn-nnn-nnnn (call or text) or xxxx@xxxx.xxx (Hermiston OR)
International LB 3-5 hp, runs good, on wheelbarrow-type cart, $450; Rich Hanna nnn-nnn-nnnn (Hayden ID)
John Deere 3 hp E, $990 or good offer; Larry Jacobson nnn-nnn-nnnn or nnn-nnn-nnnn (Salt Lake City UT)
John Deere LUC 12 hp power unit, 2 cylinder, from a John Deere 12A pull-type combine. Very good metal, pulley and clutch. Needs exhaust pipe replaced, $400; Richard Hanna nnn-nnn-nnnn (Hayden ID)
Le Roi 2-cylinder 8 hp upright on steel-wheeled cart, model MH3. Good condition, not running, not stuck. Used to run a buzz saw. In storage since 1995, $300; Richard Hanna nnn-nnn-nnnn (Hayden ID)
Magnetos: Lot of magnetos from one to six cylinder; Richard Parker nnn-nnn-nnnn (Lind WA)
Marine engines: Mohawk marine engine, very rare, magneto ignition, $400. Missouri marine engine, $150. Crescent marine engine made in St Louis MO in 1911, $300; Buck nnn-nnn-nnnn (Greenville IL)
Maytag twin rope pull start, runs good, $150; Rich Hanna nnn-nnn-nnnn (Hayden ID)
Mogul 6 hp with original skids and fuel tank, $7000; James nnn-nnn-nnnn after 6PM (Lumby BC Canada)
Novo 2 or 2-1/2 hp (no tag), runs with external gas tank, adapted carb, car points, oil, battery, $450; Richard Hanna nnn-nnn-nnnn (Hayden ID)
Rix engine/air compressor. Engine has one power cylinder and one compressor cylinder. Has freeze crack repair on water jacket. Stuck. Comes with 2 spare Bosch magnetos. Email for pictures, $350; Tanner Remillard nnn-nnn-nnnn or xxxx@xxxx.xxx (Pendleton OR)
Samson 8 hp, complete except for the oil splash plate in back. Has not been painted. On nice iron wheel cart. Has been running on propane. It has the gas bowl if you want to run it on gas, $6500; Wilbur Reil nnn-nnn-nnnn (Davis CA)
Waterloo Boy engine, disassembled, has block, head, crank, piston and misc parts. Not complete, good for parts or rebuild, $150 obo; Brad Petersen nnn-nnn-nnnn (Cloverdale CA)
Wisconsin engine, small $85; Don Chappell nnn-nnn-nnnn (St Helens OR)
Wisconsin V4, stuck. Electric start, $90 or good offer; Larry Jacobson nnn-nnn-nnnn or nnn-nnn-nnnn (Salt Lake City UT)
Wisconsin V4. Ran when it was put in storage, $200 or good offer; Larry Jacobson nnn-nnn-nnnn or nnn-nnn-nnnn (Salt Lake City UT)
Wisconsin VF4D engines; Richard Parker nnn-nnn-nnnn (Lind WA)
Witte 4 hp headless, 1915, with brass tag, on skids. Not running. Stored inside, $600; Richard Hanna nnn-nnn-nnnn (Hayden ID)