Aermotor open gear windmill wanted, complete or parts, any condition. Also want brake shoe for 10 ft Aermotor open gear, part #B190; Tony Giefer nnn-nnn-nnnn (Lindsay CA)
Ammunition wanted (antique); Hank Weigel nnn-nnn-nnnn (Carlton OR)
Guns wanted: pre-1898 rifles and pistols; Hank nnn-nnn-nnnn (Carlton OR)
Info needed: I have two large cast iron wheels that I would like to know what they fit, both are 39-3/4 in diameter. One has 5 spokes, the other has 6, there is a casting number of A455N and the Case tractor emblem on one wheel. They are 4-1/4 in wide and appear to be crowned for a belt. One is for a keyed shaft about 1-7/8 and the other looks to be for a tapered shaft. Any help would be greatly appreciated; Jerry Bird nnn-nnn-nnnn (John Day OR)
John Deere 48 loader wanted for a 1020 John Deere; Mark Haithwaite nnn-nnn-nnnn (Cawston BC)
Old advertising signs of any type, cardboard, tin or enamel, advertising anything wanted; Joe Giordano nnn-nnn-nnnn or xxxx@xxxx.xxx (Port Orchard WA)
Old and unusual California license plates wanted. Looking for pre-1919 passenger plates especially 1905-1913 and any old Cal motorcycle plates 1914 - current issue especially 1914-1919; Greg Campbell nnn-nnn-nnnn or xxxx@xxxx.xxx (somewhere in CA?)
Polaris Sno-Traveler wanted, specifically a Voyager model. I may also look at a K-95; Ryan Gurney nnn-nnn-nnnn (Filer ID)
Torbensen rear axle. Axle ratio approximately 3.75 to 1. Total overall width 52-3/4 inches. Make offer; Gerald Hilden nnn-nnn-nnnn or xxxx@xxxx.xxx (Olympia WA)
Trailer wanted: 2 axle 20 foot goose neck trailer; Larry Busack nnn-nnn-nnnn (Longview WA)
Want John Deere ground driven corn binder; Dave nnn-nnn-nnnn (Boring OR)
Want old horse drawn equipment, complete or in parts, also especially looking for a complete horse drawn grader; Gary Martin nnn-nnn-nnnn (Bieber CA)
Wanted for Homelite XL924 power saw: tune up parts, coil condenser & points or source needed; Garry Bevier nnn-nnn-nnnn (Yamhill OR)