1921 Ford Model T delivery truck, restored, $8000; Hubert Bierly nnn-nnn-nnnn (Bend OR)
1938 Ford sedan delivery Mustang II, solid body, $5500, trades considered; Mark Willanger nnn-nnn-nnnn (Mt Vernon WA)
1939 Plymouth all original coupe like the ones in Roger Rabbit, original upholstery, new headliner, 58000 miles, new running boards. Won numerous awards, pearl white with burgundy fenders, real head turner, can email photos to interested people only. Owned the car over 45 years and hate to sell, but the time has come, $25000 obo; Carol nnn-nnn-nnnn (Keno OR)
1946-1948 Mercury Flathead, V8, 100 hp, 59 A-B heads, $975; Don Chappell nnn-nnn-nnnn (St. Helens OR)
1947 International KB5 flatbed 1-1/2 ton truck, decent project truck, not running, $400; Milton Nichols nnn-nnn-nnnn (Red Bluff CA)
1948 International panel/delivery truck, KB2, no motor or transmission, frame solid, has had body work done to it, but needs much more, really neat looking truck, needs ground up restoration, make a good offer; Joe Giordano nnn-nnn-nnnn or xxxx@xxxx.xxx (Port Orchard WA)
1950 Ford sedan chassis, no engine or transmission, very good condition, has 1965 Mustang rear end (rare), $275; Wendell Newman nnn-nnn-nnnn (Carson City NV)
1951 Chevrolet 1-1/2 ton flatbed truck, decent project truck, not running, $400; Milton Nichols nnn-nnn-nnnn (Red Bluff CA)
1952 American LaFrance Model 700 fire truck pumper, 33000 original miles, ex city of Red Bluff CA engine, runs and drives with a good running International 549 V8 which was department installed in 1974, brand new front tires, have lots of spare parts to go with it, $5200; Tim Morris nnn-nnn-nnnn (Napa CA)
1953 Chevrolet sedan delivery rolling chassis, minor rust, clean title, $2750; Mark Willanger nnn-nnn-nnnn (Mt Vernon WA)
1957 Chevrolet 283, turns over, heads and intake manifold stored inside, $100 cash; Mike nnn-nnn-nnnn (Puyallup WA)
1964 Chevrolet Chevelle El Camino, ex-California car, very solid, bed is almost perfect, has V8 with Powerglide, interior is good, comes with original canopy, car sat for 30 years in a dry garage, has not run since, motor does turn over, floorboards, fenders everything very solid, would make easy restoration, hard to find a car in this nice of condition, clean title, $6700; Joe Giordano nnn-nnn-nnnn or xxxx@xxxx.xxx (Port Orchard WA)
1965 Ford F250, 390 engine not in truck, two-inch body lift, limited slip differential, 4 speed transmission, body good, some rust at drip rail and front of hood, parked for 10 some years, non-op papers, $1500; Don Newton nnn-nnn-nnnn (San Miguel CA)
1968 Chevrolet C20 panel truck, factory 396, 4 speed, needs restoration, clean title, $750; Mark Willanger nnn-nnn-nnnn (Mt Vernon WA)
1968 International dump truck, 5-yard, cab over, gas, 5+2, air brakes, runs but needs work, excellent box with subframe, title in hand, $1950 obo; Don Chappell nnn-nnn-nnnn (St. Helens OR)
1980 Bronco, 4x4, 302 engine, ran when parked in garage some 14 years ago, non op papers, no body damage, only rust at bottom of tail gate, as is, $3500; Don Newton nnn-nnn-nnnn (San Miguel CA)
1980s motor home stripped chassis, fuel control, 4 wheel disc brakes, great for old COE swap, clean title, $500; Mark Willanger nnn-nnn-nnnn (Mt Vernon WA)
1981 Kentucky 30 ft van trailer with large hydraulic rear loading ramp (needs work), wide right side door center, wide right side door near rear, clean California title, $4500 obo; Robert McLaughlin nnn-nnn-nnnn (Benton City WA)
AMF moped, vintage, use to carry Harley name also, needs restoration, motor turns over, good shape, but sat for many years in a barn, $275; Joe Giordano nnn-nnn-nnnn or xxxx@xxxx.xxx (Port Orchard WA)
Chevrolet 153 4-cylinder engine, core engine, option in General Motor trucks and Chevy II, $150 obo; T Van Tassel nnn-nnn-nnnn (Richmond CA)
Chevrolet 235, core engine, in pieces, $100 obo; T Van Tassel nnn-nnn-nnnn (Richmond CA)
Cummins 262, 743 cubic inch engine, complete drop in vehicle ready engine that runs extremely well. Not sure of mileage or last overhaul. Knew previous owner who took very good care of his equipment, $1950; Tim Morris nnn-nnn-nnnn (Napa CA)
Durant Car engine, #W5-498539 with clutch and water pump, made by Continental or Durant, 4 cylinder, not stuck, $225 obo; Larry Jacobson nnn-nnn-nnnn or nnn-nnn-nnnn (Salt Lake City UT)
Ford car parts, 1949-1951, have lots; Wendell Newman nnn-nnn-nnnn (Carson City NV)
General Motors rear axle, complete with pumpkin, believed to be from a 50s vintage GM passenger car, perhaps an Oldsmobile, five lug on 5-inch spacing, great original unit, unknown gear ratio, nothing fits better than original GM part for your project vehicle, $50; Ray Dias nnn-nnn-nnnn (Hughson CA)
GMC trucks: 1954 Model 450 with Heil dump body. 1954 Model 450 flatbed (steel). 1952 Model 350 flatbed. 1952 Model 400 ten wheel can and chassis 5/3/2. 1948 Model 250 one-ton panel. All have good sheet metal and runnable. Looking for serious buyers and reasonable offers; John LaBoyteaux nnn-nnn-nnnn (Redcrest CA)
Honda 55 Trail from the 1960s, no title, motor stuck, lots of good parts, $275; Joe Giordano nnn-nnn-nnnn or xxxx@xxxx.xxx (Port Orchard WA)
Lumber rack, custom built, fits 1976 F150, $350; Rocky Jones nnn-nnn-nnnn (Cave Junction OR)
Wanted: 1947-54 Chevrolet/GMC 3800 series one-ton pickup; John LaBoyteaux nnn-nnn-nnnn (Upper Lake CA)
Wanted: 1960s Dodge Power Wagon in running and driving condition; Tanner Remillard nnn-nnn-nnnn or xxxx@xxxx.xxx (Pendleton OR)
Wanted: KR Wilson Ford front axle alignment tool kits number 525, 526 and ABU89; Harry Lindahl nnn-nnn-nnnn no messages (Richvale CA)
Wanted: looking for cab over truck from the 1940s; Jim Brown nnn-nnn-nnnn (Lumby BC)