1938 Ford sedan delivery Mustang II, solid body, $5500, trades considered; Mark Willanger nnn-nnn-nnnn (Mt Vernon WA)
1947 International KB5 flatbed 1-1/2 ton truck, decent project truck, not running, $400; Milton Nichols nnn-nnn-nnnn (Red Bluff CA)
1948 International KB-2 panel delivery, no motor or transmission, have some glass and trim, rolling chassis, frame solid, body quite good, very restorable machine, make offer; Joe Giordano nnn-nnn-nnnn or xxxx@xxxx.xxx (Port Orchard WA)
1950 Ford F4, original flathead V8, just under 29500 original miles, runs and drives, nice original truck that is not beat up or rusted out, $3400 obo; Chris Jerue nnn-nnn-nnnn (Cheney WA)
1951 Chevrolet 1-1/2 ton flatbed truck, decent project truck, not running, $400; Milton Nichols nnn-nnn-nnnn (Red Bluff CA)
1952 American LaFrance Model 700 fire truck pumper, 33000 original miles, ex city of Red Bluff CA engine, runs and drives with a good running International 549 V8 which was department installed in 1974, brand new front tires, have lots of spare parts to go with it, $5200; Tim Morris nnn-nnn-nnnn (Napa CA)
1953 Chevrolet sedan delivery rolling chassis, minor rust, clean title, $2750; Mark Willanger nnn-nnn-nnnn (Mt Vernon WA)
1955 Jeep, military, M38-2A, call for info; Don Chappell nnn-nnn-nnnn (St Helens OR)
1966 Ford F703 reconditioned truck, rebuilt 30 V8, recent new rubber/gaskets on all windows, very good driving truck, no rust, full air brake, with air over electric towing connections, set up for gooseneck application, make offer; Robert Mclaughlin nnn-nnn-nnnn (Benton City WA)
1968 Chevrolet C20 panel truck, factory 396, 4 speed, needs restoration, clean title, $750; Mark Willanger nnn-nnn-nnnn (Mt Vernon WA)
1978 Mercedes 450 SLC, just under 68000 miles with V8 engine. Rust free nice body condition, been parked in a shed for the last 2 years and is on CA non-op status. Tires are 10 years old and heater/AC not working, selling because it is too difficult to get in/out of at my age, can send photos via text or email, $3500; Frank Busch nnn-nnn-nnnn (Morgan Hill CA)
1980s motor home stripped chassis, fuel control, 4 wheel disc brakes, great for old COE swap, clean title, $500; Mark Willanger nnn-nnn-nnnn (Mt Vernon WA)
Chevrolet 153 4-cylinder engine, core engine, option in General Motor trucks and Chevy II, $150 obo; T Van Tassel nnn-nnn-nnnn (Richmond CA)
Chevrolet 235, core engine, in pieces, $100 obo; T Van Tassel nnn-nnn-nnnn (Richmond CA)
Cummins 262, 743 cubic inch engine, complete drop in vehicle ready engine that runs extremely well. Not sure of mileage or last overhaul. Knew previous owner who took very good care of his equipment, $1950; Tim Morris nnn-nnn-nnnn (Napa CA)
Durant car engine, #W5-498539 with clutch and water pump, engine made by Continental or Durant, 4 cylinder, not stuck, $200 obo; Larry Jacobson nnn-nnn-nnnn or nnn-nnn-nnnn (Salt Lake City UT)
General Motors rear axle, complete with pumpkin, believed to be from a 50s vintage GM passenger car, perhaps an Oldsmobile, five lug on 5-inch spacing, great original unit, unknown gear ratio, nothing fits better than original GM part for your project vehicle, $50; Ray Dias nnn-nnn-nnnn (Hughson CA)
Gremlin hub cap, 1974; Joe Keith nnn-nnn-nnnn (Hermiston OR)
Volkswagen bugs and numerous parts. Also a VW powered street legal on road/off road buggy; Robert Mclaughlin nnn-nnn-nnnn (Benton City WA)
Wanted: Jeeps flat fender bodies or early Jeep engines, chassis, wheels, etc; Richard nnn-nnn-nnnn (Milton-Freewater OR)
Wanted: KR Wilson Ford front axle alignment tool kits number 525, 526 and ABU89; Harry Lindahl nnn-nnn-nnnn no messages (Richvale CA)
Wanted: looking for cab over truck from the 1940s; Jim Brown nnn-nnn-nnnn (Lumby BC)
Wanted: Old Powerwagon parts, currently restoring 1946 WDX Powerwagon, let me know what you have, parts trucks or parts laying around; David Kraemer nnn-nnn-nnnn (Kennewick WA)