Briggs and Stratton engines, three to eight horsepower, all complete for mowers, pumps, etc. all priced under $50; Dave Pearsall nnn-nnn-nnnn or xxxx@xxxx.xxx (Olympia WA)
Case stationary 284, LP, complete less radiator and sheet metal, has clutch, mounts, gauges, turns over easy by hand, has cracks in block that have been repaired, same as a Case 830 gas tractor engine; Rick Newman nnn-nnn-nnnn or xxxx@xxxx.xxx (Bozeman MT)
Christensen, 5 hp, side shaft, SN 6695, original finish on fabricated steel truck, starts easy, runs very slow; Gerry nnn-nnn-nnnn (Eatonville WA)
Cushman Binder engine, older restoration, $200; Tom Dessert nnn-nnn-nnnn (Ridgefield WA)
Cushman, 4 hp, one flywheel and clutch on the other side for four-inch belting, turns over, $300; Ray Bathrick nnn-nnn-nnnn (North Bend OR)
Detroit engine, 92 series starter, $50 obo; Jim Ronsse nnn-nnn-nnnn (Chicago Park CA)
Doak, 5 hp, hit and miss, on nice cart, ignitor ignition, can send pictures, $9200; Danny Ponce nnn-nnn-nnnn (Los Angeles CA)
Economy XK, 4 hp, EK magneto, nice pulley, has compression, nice shop built cart, reproduction muffler, no cracks/breaks/welds can be seen, restored, good paint, show ready with a little TLC, engine hasn’t run for a while, $650; Jim Beeler nnn-nnn-nnnn or xxxx@xxxx.xxx (Tacoma WA)
Economy, 1-1/2 hp, Webster magneto, needs restoration, $350; Tom Dessert nnn-nnn-nnnn (Ridgefield WA)
Engine collection: six John Deere 1-1/2 hp. Two Sattley 1-1/2 hp. International Harvester 1-1/2-2-1/2 hp with air cleaner. Novo 2 hp. Stover 3 hp. Associated 1-1/2 hp. McCormick Deering 1-1/2 hp. Stover 2-2-1/2 hp law tractor, must see. JD 1-1/2 hp, partially rebuilt. Packaged deal, all or none. All are loose, most have carts (trucks), “Not Junk”, $10000 for all; Chuck nnn-nnn-nnnn (John Day OR)
Engine collection: two Stovers, one Alamo, one Fairbanks Morse, two Internationals, one New Way vertical, one 4 hp Lawson Frost King on original cart, all in great shape, pictures on request; Jess Riker nnn-nnn-nnnn (Beaver UT)
Fairbanks Morse N, 20 hp, build date of 10/1910, engine runs and has been shown at the Great Oregon Steam Up in Brooks OR, pictures available on request, $18000; Gary Strausbaugh nnn-nnn-nnnn or xxxx@xxxx.xxx (Magnolia TX)
Fairbanks Morse Z, 6 hp, very hot magneto, engine mounted on highly varnished wood runners, older restoration by master craftsman Paul Pearman who was entrusted to restore antique luxury cars belonging to Jay Leno, $1125; Dave Pearsall nnn-nnn-nnnn or xxxx@xxxx.xxx (Olympia WA)
Fairbanks Morse, 1-1/2 hp, unrestored, $250; Tom Dessert nnn-nnn-nnnn (Ridgefield WA)
Fairbanks Morse, 6 hp, unrestored, $300; Tom Dessert nnn-nnn-nnnn (Ridgefield WA)
Fairbanks type R magneto, very hot spark, drive gear very good, $325; Dave Pearsall nnn-nnn-nnnn or xxxx@xxxx.xxx (Olympia WA)
Fairbanks, 1-1/2 hp dishpan parts engine, $50; Dave nnn-nnn-nnnn (Aurora OR)
Field Brundage, 1-1/2 hp?, no tag, no gas tank, no magneto, has ignitor/timing bracket, no oiler, on skids, no cracks/breaks/welds seen, $350; Jim Beeler nnn-nnn-nnnn or xxxx@xxxx.xxx (Tacoma WA)
Fuller and Johnson pump jack engine with new fuel tank with newly foundered gas mix valve, $875; Dave Pearsall nnn-nnn-nnnn or xxxx@xxxx.xxx (Olympia WA)
Gardner 1L2, 10 hp, single cylinder diesel, starts easy and runs great, on steel truck; Gerry nnn-nnn-nnnn (Eatonville WA)
Grey model T, 5 hp, vertical, two cycle, marine engine, about 1915, on cart with water tank and circulating pump, $650; Danny Ponce nnn-nnn-nnnn (Los Angeles CA)
Hecules IXB5, with clutch and starter, $200 obo; Bob Arndt nnn-nnn-nnnn (Cromberg CA)
International Famous, 4 hp, 1910, hit and miss, ignitor ignition, hopper cooled, on nice cart, runs good, can send pictures, $4300; Danny Ponce nnn-nnn-nnnn (Los Angeles CA)
John Deere, 1-1/2 hp, early big brass tag, $600; Tom Dessert nnn-nnn-nnnn (Ridgefield WA)
Maytag engines for sale, five 92s and one upright, pictures on request, $250-$750; Jess Riker nnn-nnn-nnnn (Beaver UT)
Meco Manufactures Engine Co., 2 hp, headless, nice paint, low on compression, battery box with buzz coil, no cracks/breaks/welds can be seen, no muffler, on wheels, show ready with a little TLC, engine hasn’t run in a long while, $600; Jim Beeler nnn-nnn-nnnn or xxxx@xxxx.xxx (Tacoma WA)
Mohawk marine engine, $750; Buck Evans nnn-nnn-nnnn (Greenville IL)
Olds Gearless, 6 hp, project engine, needs several parts made, needs a large repair to the outside of the water jacket – has a large hole cut out to install a hopper on a tank cooled engine, has 40 inch flywheels, $5500; Les nnn-nnn-nnnn (Salem OR)
Samson, 6 hp, on iron wheel cart, painted, runs on gasoline, has been shown many times, $6000; Wilbur Reil nnn-nnn-nnnn (Davis CA)
Sandwich Model AB, 1-1/2 hp, EK magneto, restored, has cracked crankshaft bearing cap, previous owner said it ran fine the way it is, nice paint, on wheels, show ready with a little TLC, engine hasn’t been run for a long time, $575; Jim Beeler nnn-nnn-nnnn or xxxx@xxxx.xxx (Tacoma WA)
Schmidt chill cylinder, 1-1/2 hp type B, rare, 1908, $3200 obo; Danny Ponce nnn-nnn-nnnn (Los Angeles CA)
Schmidt chill cylinder, 3 hp type H, SN X7597, 1907, buzz coil, $2500; Danny Ponce nnn-nnn-nnnn (Los Angeles CA)
Sheldon, 2 hp, complete, has Webster magneto, crank guard, belt pulley, good compression, barn fresh, nice little rare engine, $600; Dave nnn-nnn-nnnn (Aurora OR)
Sparta Economy, 2 hp, good compression, still had long crank shaft, older restoration, good paint, no cracks/breaks/welds can be seen, on nice shop built cart, no muffler, will need a coil and battery, has good tag, ready to show with a little TLC, has not been running in a long time, $650; Jim Beeler nnn-nnn-nnnn or xxxx@xxxx.xxx (Tacoma WA)
Stickney, 1-3/4 hp, fuel pump, clutch pulley, brass piping, new cylinder sleeve, reproduction riveted truck; Gerry nnn-nnn-nnnn (Eatonville WA)
Stickney, 3 hp, fuel pump, clutch pulley, brass piping, new cylinder sleeve, paint is Stickney Blue on reproduction riveted truck; Gerry nnn-nnn-nnnn (Eatonville WA)
Stover CT 2, Wico EK magneto, $225; Tom Dessert nnn-nnn-nnnn (Ridgefield WA)
Stover, 4 hp, SN T37922 model T, mounted on an engine truck, restored, $1000; Tom Dessert nnn-nnn-nnnn (Ridgefield WA)
Wade draw saw, magneto and all there, ran a year ago, stored inside, $400; Lew Ward nnn-nnn-nnnn (Brush Prairie WA)
Wisconsin engines, one- and two-cylinder complete engines with magnetos, just too numerous to list, you will need to inspect; Dave Pearsall nnn-nnn-nnnn or xxxx@xxxx.xxx (Olympia WA)
Wisconsin V4 from hay baler with clutch and starter, $300 obo; Bob Arndt nnn-nnn-nnnn (Cromberg CA)