January 2020 - Vehicles

All Classified Ads

1908 Kelly K13 chain drive chuck; Buck nnn-nnn-nnnn (Ellensburg WA)

1923 Buick 263 cubic inch engine, last of the straight eights, incredible condition but mostly dismantled, standard bore with less than .005 inch taper, standard rod bearings, standard main bearings, flywheel and bellhousing for manual transmission, no manifold or accessories, excellent upgrade for an earlier series 40 or 50 Buick, $400 or may trade; Chuck nnn-nnn-nnnn is landline or xxxx@xxxx.xxx (San Jose CA)

1924 Dodge business coupe, runs; Buck Charles nnn-nnn-nnnn (Ellensberg WA)

1926 Ford Model T touring, restored; Buck Charles nnn-nnn-nnnn (Ellensberg WA)

1928 Ford Model A steering column with remnants or original red steering wheel, $75; Todd Penery nnn-nnn-nnnn (Placerville CA)

1936 Oldsmobile F36 4 door, California car, 49000 original miles, paint, chrome and interior all good, no rust, six-cylinder engine runs, drives, stops, $6000 obo; Dennis King nnn-nnn-nnnn or xxxx@xxxx.xxx (Graham WA)

1948 International KB truck glass, brand new, side windows and windshield, etc. $350 takes all, can ship; Joe Giordano nnn-nnn-nnnn or xxxx@xxxx.xxx (Port Orchard WA)

1951 Willys Wagon, 2WD, four cylinder engine, three speed with overdrive, runs and drives but smokes, body good, very few dents, some rust on the floor in front of seats and on passenger side door, new water pump, radiator cleaned, new wheel cylinders and brake lines, new wiring years ago, clean CA title with non-operation, $2500; Dave nnn-nnn-nnnn (Scotia CA)

1953/54 Ford F-3 cab and chassis, not running, model F35V5R, 113 hp, V8 overhead valve engine, four speed transmission, 5.83 rear axle ratio, cab relatively straight and minimal rust, rear outside duals missing, $800; John Nye nnn-nnn-nnnn (Delta UT)

1956 Chevrolet Model 6400, truck was ordered new from the Dalles OR dealer with all the Cameo Carrier options, bright trim, big back window, special seat, also has 9.22x5 tires, 261 engine, 5 speed transmission, two speed rear end, 12 foot bed, must sell due to age/health, $5500, would consider trade for utility/compact 20-30 hp tractor/loader with power steering; Russ Shorten nnn-nnn-nnnn – corrected phone (Dayton WA)

1966-68 Mustang wheel covers, $10 each. 20 old hubcaps (Ford, Buick, Dodge, miscellaneous), $5 each; Jerry VanDeWalle nnn-nnn-nnnn (Yamhill OR)

1967 Ford Econoline Classis, runs good, looks good, six cylinder with automatic, as is, $10000; Don Roberts nnn-nnn-nnnn (Crooked River Ranch OR)

1971 International 1210, 3/4-ton flatbed, 304 V8, four speed, runs good; Fred nnn-nnn-nnnn (Bandon OR)

1984 Ford E350 cargo van, 300 cubic inch 6 cylinder, three on the tree, needs work, very straight truck, $1295; $2995 obo; Don Chappell nnn-nnn-nnnn (St Helens OR)

1986 Ford F350 shop/tire truck, 6.9 diesel, 10 foot bed, big air compressor, one inch gun – some parts and tools, oxy/acetylene torch, drive anywhere, $2750, possible trade, no boats; Fred nnn-nnn-nnnn (Bandon OR)

1987 Ford Ranger pickup, 1/4 ton, been parked for a number of years, have “pink slip” in hand, good paper and is on “non-op”, ex Santa Fe railroad, with Fairmont hyrail attachment, $2000, can text photos; Jon Rodgers nnn-nnn-nnnn (Sonora CA)

2002 Ford Excursion, 4x4, 7.3 Power Stroke, second owner, dealer maintained, pictures available; Sandee nnn-nnn-nnnn (Bandon OR)

2005 Ford F350, 4x4, crew cab, 6.0 Power Stroke diesel, engine has been upgraded and bulletproofed with new heads and stud bolts, new battery, starter and water pump, rebuilt turbo and injectors, blue exterior and grey leather interior, Lariat package with all power options, new tires, never been wrecked, truck is in emasculate condition, has lots of pulling power, automatic transmission, $16500 cash or might take some trade; Dick Benson nnn-nnn-nnnn (Grants Pass OR)

Chevrolet big block, 366, truck motor, $550; Fred Scholee nnn-nnn-nnnn (Elgin OR)

Ford 215 cubic inch, six cylinder, OHOV, $300 each, two available; Vern Fought nnn-nnn-nnnn (Exeter CA)

Ford 223 cubic inch, 6-cylinder, OHV, $300 each or $1000 for all three; Vern Fought nnn-nnn-nnnn (Exeter CA)

Fords: 1930 Model A Tudor, restored with overdrive. 1930 Model A Tudor, restored, with V8 60 flathead, hydraulic brake. Buck Charles nnn-nnn-nnnn (Ellensberg WA)

General Motors 5500 cab, 1972, complete, good condition, $850; Fred Scholee nnn-nnn-nnnn (Elgin OR)

International S models, low profile, one runs, one doesn’t, 1-1/2-ton trucks; Bill Elzey nnn-nnn-nnnn (Touchet WA)

Manual, Jeep FC150 and FC170 original shop/dealer manual, came with 1957 FC150 but sold it years ago, manual has one small faded fingerprint, all 464 pages very clean and binding excellent, should complete a Jeep FC150 or FC170 owner’s glovebox; Dave Pearsall nnn-nnn-nnnn or xxxx@xxxx.xxx (Olympia WA)

Parting out: 1954 Mercury two door sedan. 1957 Ford four door sedan. 1957 Ford four door station wagon; Mark Willanger nnn-nnn-nnnn (Prescott WA)

Pickup utility box canopy, 6’4”x9’3”, shelves on each side, no tail gate, overall good condition, can email pictures, reduced price $495; Ronn Boehlke nnn-nnn-nnnn or xxxx@xxxx.xxx (Klamath Falls OR)

Title for 1931 Chevrolet two door, $75; Mark Willanger nnn-nnn-nnnn (Prescott WA)

Wanted 1927 International 3/4-ton parts and usable flywheel for Waukesha X engine; Jim Barratt nnn-nnn-nnnn or xxxx@xxxx.xxx (Camas WA)

Wanted White parts for 1919 model 45 five-ton truck, dead or alive; Jim Barratt nnn-nnn-nnnn or xxxx@xxxx.xxx (Camas WA)

Wanted: 1974 International 345/392/V8 right hand exhaust manifold; Mark Willanger nnn-nnn-nnnn (Prescott WA)

Wanted: Autocar truck parts, mid to late 1950s, need grille parts and name badge; Garry Bevier nnn-nnn-nnnn (Yamhill OR)

Wanted: International rear box fenders from early 1950s; Mark Willanger nnn-nnn-nnnn (Prescott WA)

Wanted: log trunk bunks, trailer and cab guard circa 1950, also set of cheese blocks for log bunks; Gary Bevier nnn-nnn-nnnn (Yamhill OR)

Wanted: right hand front fender for 1961 International Scout; Mark Willanger nnn-nnn-nnnn (Prescott WA)